Join the conversation You can post now and register later. I'm running on 6. Testing on the EHF will reveal whether they are compatible or not. An alarm is triggered if the rotation speed has dropped below a programmable limit. Mapping of temperatures to pwm outputs is as follows: 
| Uploader: | Fenrile |
| Date Added: | 24 July 2008 |
| File Size: | 57.57 Mb |
| Operating Systems: | Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X |
| Downloads: | 8152 |
| Price: | Free* [*Free Regsitration Required] |
Reply to this topic. An alarm is triggered when the temperature gets higher than high limit; it stays on until the temperature falls below the hysteresis value.
This mode is not yet supported by the driver. Only 75 emoji are allowed. Reply to this topic Posted March 20, The driver w83627eht the most suitable fan divisor itself.
An alarm is triggered if the rotation speed has dropped below a programmable limit. The Linux Kernel 5. The driver supports automatic fan control mode known as Thermal Cruise. Note that bank selection must be performed as is currently done in the driver for all register addresses.
Once i removed this plugin i w38627ehf the server off and left it for 8 hours, IPMI sensors still showing correctly, no alarms or errors.
Kernel driver wehf — The Linux Kernel documentation
If your setup show more than one PWM interface, select it and try Detect and see if it slows down the CPU fan and choose one port that doesn't. However i never had a case of this happening prior to V6 w83627hef unraid The alarms - But i suspect this w83627rhf due to the fact i never had any sensor detection happening prior to V6.
Temperatures are measured in degrees Celsius and measurement resolution is 1 degC for temp1 and and 0. The mode works for fan1-fan4. Fan rotation speeds are reported in RPM rotations per minute. Upload or insert images from URL. Go To Topic Listing. Insert image from URL.
Alarms are only supported for temp1, temp2, dtiver temp3. I had to manually edit it to bergwares github version updated 12 days ago.
'lm-sensors: hardware monitoring with the wehf module'
Some registers also have different power-on default values, but BIOS should already be loading appropriate defaults. SmartFan IV operational parameters can not be configured at this time, and the various pwm attributes are not ddiver in SmartFan IV mode. Also i feel i should mention, incase it sheds some light on things the 'auto fan script' as-is doesn't currently detect anything for me. I'm running on 6.
CONFIG_SENSORS_W83627EHF: Winbond W83627EHF/EHG/DHG/UHG, W83667HG, NCT6775F, NCT6776F
Future driver development should bear in mind that the following registers have different functions on the EHF and the DHG. Still just a bit confused as to why when the driver is loaded into unraid the IPMI device sees crazy RPM values Even without the auto fan script installed it was doing this. Display as a link instead.
Once the temperature leaves the interval, fan speed increases temp is higher or decreases if lower than desired.
This is not a driver malfunction. An alarm is triggered if the voltage has crossed a programmable minimum or maximum limit.
Sign In Sign Up. I'm not sure if this is something that can be fixed by you, or perhaps its something wrong on my end, but it all seems to point to the driver to me, i can of course do without it, but controlling my fans speed would be nice!
See were how w83627egf change the IPMI thresholds: In this mode, the chip attempts to keep w83627ef measured temperature in a predefined temperature range.
No comments:
Post a Comment