December 14, at 6: February 3, at 6: Do you think updating to. Can you please advise me on the following scenario: November 25, at 5: PC is at Download default IOS tar image tftp: 
| Uploader: | Jule |
| Date Added: | 16 February 2014 |
| File Size: | 45.7 Mb |
| Operating Systems: | Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X |
| Downloads: | 28725 |
| Price: | Free* [*Free Regsitration Required] |
Cisco Aironet AIR-AP1242AG-C-K9 Access Point
These files are smaller than the fully functional k9w8 files. The process is rather straightforward when converting an Autonomous AP to Lightweight.
Rename the access point image file in the TFTP server folder to ap3g2-k9w7-tar. Did you specify your TFTP server correctly?
If it is, try this method https: When Cisco acquired Airespace inthey sponsored an effort to standardized this protocol. October 2, at 5: It came up on the k9w7 image which is autonomous. Download the software image from Cisco.
Pls check the data sheet of this AP model where it listed the different Tx power level it operates. May 17, at 5: January 7, at 4: JA7 8 -rwx Mar 1 It concludes my tutorial on converting Cisco Wireless Access Point from Lightweight mode to Autonomous mode and vice versa. You may want to just copy and paste from here. May 9, at 7: It enables you to enter configuration mode.
Refer below deployment guide for that conversion https: Hi, Thanks for the great information.
August 22, at 8: Download the Lightweight image from Cisco. Question…New version would be ck9w7-tar. You need to download the required IOS image from Cisco.
My CCNA Wireless Journal: Cisco AP IOS Upgrade for WPA2 Support
It is really useful. Thanks in advance, Akhil Vijay Reply. When I set power AP while pressing the mode button, after releasing the button, I get error message on console: JA8" AP that is running in Autonomous mode: Here is what I followed 1.
February 3, at Please let me know if supports Lightweight to Autonomous Mode? When the default gateway is set to the AP ip-address itself, it tries to resolve the controller and is stuck in the following loop: Please do let me know your observation when you power using PoE switch.
Then I set the boot system as k9w7.
Compiled Thu Dec No Problem, glad it helps you Rasika Reply.
No comments:
Post a Comment